Module 9135 Switch On 3-D Touch Probe - HEIDENHAIN TNC 426 PB/M Technical Manual

Table of Contents

6.15 Touch Probe

The following touch probes can be connected:

Touch trigger probes

• TS 120, TS 220: With cable connection for digitizing, tool setup and

measuring during machining

• TS 632: With infrared transmission for workpiece setup and

measurement during machining

• TT 130: For tool measurement

Measuring touch probe

For connecting the touch probes: (See "Mounting and Electrical Installation"

on page 3 – 5).

With MP6010 and MP6200, specify which touch probes are connected.

Make sure that the spindle is locked during the measuring process.

With FN18 you can read the current touch probe data.

Selection of the touch probe

0: Touch probe with cable transmission

1: Touch probe with infrared transmission

Selection of triggering or measuring touch probe (only with

"digitizing with measuring touch probe" option)

0: Triggering touch probe (e.g. TS 220)

1: Measuring touch probe

The TNC 426/430 always emits a start signal when beginning a touch probe

cycle, meaning Module 9135 does not need to be used for HEIDENHAIN

touch probes.

Module 9135 Switch on 3-D touch probe

With Module 9135 you can switch on or retrigger certain 3-D touch probes. If

the touch probe is already switched on, the module call has no effect. If

M4056 is set and the touch probe does not provide a ready signal, the feed-

rate enabling (M4563) is reset.

Error recognition:

Error in module run

HEIDENHAIN Technical Manual TNC 426, TNC 430