Automatic Calculation Of Cutting Data - HEIDENHAIN TNC 426 PB/M Technical Manual

6.21.2 Automatic Calculation of Cutting Data

As of NC software:
280 472-01
Tool table
6 – 418
The optimum spindle speed and the corresponding contouring feed rate is
calculated from the values entered in cutting tables for the tool and workpiece
material.
For cutters, the cutting data table lists the cutting speed and the feed rate per
tooth. For drills it lists the feed rate per revolution.
⋅
v 1000
---------------- -
c
S
=
d π ⋅
S: Spindle speed [rpm]
v : Cutting speed [m/min]
c
d: Tool diameter [mm]
Milling cutter: F = f · S
z
F: Feed rate [mm/min]
f : Feed rate per tooth [mm]
z
z: Number of teeth
Drill: F = f · S
u
f : Feed rate per revolution [mm]
u
7 7 7 7 In the .CDT column of the tool table, enter the name of the cutting data table
that is to be used for that tool.
7 7 7 7 In the TYP column define the type of tool:
• DRILL = drilling tool
• TAP = tapping tool
• MILL = milling cutter
7 7 7 7
Enter the following values in the table:
• Tool radius R
• Tool material TMAT
• For cutter: Number of teeth CUT
The tool types are defined in the file PLC.\TTYP.TAB.
If you edit this file, you must enter the new name and path in the system file
OEM.SYS using the command TTYP=.
HEIDENHAIN Technical Manual TNC 426, TNC 430