HEIDENHAIN TNC 426 PB/M Technical Manual page 274

MP Function and input
MP4060.0-8 Traverse distance for lubrication of axes 1 to 9
Input:
MP4070 Compensation amount per PLC cycle for lagged-tracking
axis error compensation
Input:
MP4110.0-47 Timer preset value T0 to T47
Input:
MP4120.0-31 Counter preset for C0 to C31
Input:
MP4130.0 Number of the high-speed PLC input for switching off the
monitoring functions
MP4130.1 Reserved
MP4130.2-5 Numerical designation for fast PLC inputs
Input:
MP4131.0 Activation criterion for fast PLC input for switching off the
monitoring functions
MP4131.1 Reserved
MP4131.2-5 Condition for activating fast PLC inputs
Input:
MP4210.0-47 Setting a number in the PLC (D768 to D956)
Input:
MP4220.0-4 Setting a number in the PLC (W960 to W968)
Input:
MP4230.0-31 Setting a number in the PLC (Module 9032)
Input:
MP4231.0-31 Setting a number in the PLC (Module 9032)
Input:
MP4310.0-6 Setting a number in the PLC (W976 to W988, M4300 to
M4411)
Input:
4 – 36
0 to 99 999.999 [mm] or [°]
0.0001 to 0.005 [mm]
0 to 65 535 [PLC cycle times]
0 to 65 535 [PLC cycles]
0 to 255 [no. of the PLC input]
TNC 426 M, TNC 430 M:
If you use I32, enter the following
values:
up to 280 474-11: MP4130.0 = 159
as of 280 474-12: MP4130.0 = 32
as of 280 476-01: MP4130.0 = 32
0: Activation at low level
1: Activation at high level
-99 999.9999 to +99 999.9999
10 to 30 000
-99 999.9999 to +99 999.9999
-99 999.9999 to +99 999.9999
10 to 30 000
HEIDENHAIN Technical Manual TNC 426, TNC 430
Software Page
version and
behavior
PLC 6 – 26
RUN
PLC 6 – 44
RUN
7 – 17
7 – 20
6 – 157
7 – 21
6 – 157
7 – 21
6 – 205
7 – 37
7 – 37
7 – 37
7 – 37