HEIDENHAIN TNC 426 PB/M Technical Manual page 540

6 – 210
M4031 and M4030 are set while the cycle runs.
F
0
S
0
M05
M4092
M4030
M4031
Start of
cycle
M4012
While Cycle 17 is running, the positioning window from MP7150 applies to the
tool axis:
7 7 7 7 Enter a value in MP7150 smaller than or equal MP1030.x.
Define the acceleration and braking process of the spindle during rigid tapping:
7 7 7 7 In MP3412.3 enter a multiplier for MP3411.x.
7 7 7 7 With MP3415.3, define the overshoot behavior of the spindle.
7 7 7 7 With MP7130, define the run-in behavior of the spindle.
S
MP3412.3
Positioning window
reached (MP7150)
Ramp from
MP3412.3
Oriented stop
MP3415.3
HEIDENHAIN Technical Manual TNC 426, TNC 430
Oriented stop
End of
cycle
MP3412.3
MP7130