Table of Contents
Advertisement
6 Machine Integration
6.1 Machine Axes
6.1.1 Selecting the Axes
Screen display
Assignment of the
axis keys
IV and V
December 2001
With MP10 you define which machine axes are to be operable.
The bits may be changed during the run-time without a control reset.
However, the bits to be changed must have been set before the control was
switched on.
Changing bits that had not been set leads to a control reset.
Note
Axis 9 may only be used as a PLC axis.
MP10
Active axes
Format:
%xxxxxxxxx
Input:
Bits 0 to 8 correspond to axes 1 to 9
0: Axis not active
1: Axis active
You can define how the axes are shown on the screen:
7 7 7 7
In MP100.x, assign a designation to each logical axis.
7 7 7 7
Define in MP7291.x the screen line in which the axis is to be displayed.
Rules for the display:
n
NC axes are designated with uppercase letters.
n
PLC axes are designated with lowercase letters.
n
Axes that are not present are given a hyphen "-".
MP100
Designation of axes
Format:
XYZABCUVWxyzabcuvw-
Input:
Characters 1 to 9 correspond to axes 1 to 9
MP100.0
Designation of axes for traverse range 1
MP100.1
Designation of axes for traverse range 2
MP100.2
Designation of axes for traverse range 3
MP7291
Display of axes on the screen
Format:
SXYZABCUVWxyzabcuvw-
Input:
Characters 1 to 9 from the right represent lines 1 to 9
Character 10 is the spindle "S", which is always output in line 9.
MP7291.0
Display in traverse range 1
MP7291.1
Display in traverse range 2
MP7291.2
Display in traverse range 3
On the keyboard unit and the HR 410 handwheel, you can assign the axis keys
IV and V as desired.
MP410
Assignment of axis keys IV and V
Input:
Axis designation XYZABCUVWxyzabcuvw-
MP410.3
Axis key IV
MP410.4
Axis key V
Machine Axes
6 – 5
Advertisement
Table of Contents
