HEIDENHAIN TNC 426 PB/M Technical Manual page 877

Group Group
name number
ID....
Cycle parameters
30
Data from the tool table
50
7 – 28
System data System data
number index
NR.... IDX....
1 –
2 –
3 –
4 –
5 –
6 –
7 –
8 –
9 –
10 –
11 –
12 –
13 –
14 –
15 –
1 Tool no.
2 Tool no.
3 Tool no.
4 Tool no.
5 Tool no.
6 Tool no.
7 Tool no.
8 Tool no.
9 Tool no.
10 Tool no.
11 Tool no.
12 Tool no.
13 Tool no.
14 Tool no.
15 Tool no.
16 Tool no.
17 Tool no.
18 Tool no.
19 Tool no.
20 Tool no.
System data item
Setup clearance
Total hole depth/milling depth
Plunging depth
Feed rate for plunging
First side length of pocket
Second side length of pocket
First side length of slot
Second side length of slot
Radius of circular pocket
Feed rate for milling
Rotational direction of the milling path
Dwell time
Thread pitch
Finishing allowance
Roughing angle
Tool length L
Tool radius R
Tool radius R2
Oversize in tool length DL
Oversize in tool radius DR
Oversize in tool radius DR2
Tool locked TL
0 = not locked, 1 = locked
Number of the replacement tool RT
Maximum tool age TIME1
Maximum tool age TIME2
Current tool age CUR. TIME
PLC status
Maximum tooth length LCUTS
Maximum plunge angle ANGLE
TT: Number of tool teeth CUT
TT: Wear tolerance in length LTOL
TT: Wear tolerance in radius RTOL
TT: Direction of rotation DIRECT
0 = positive, –1 = negative
TT: Offset in plane R-OFFS
R = 99 999.9999
TT: Offset in length L-OFFS
HEIDENHAIN Technical Manual TNC 426, TNC 430