Table of Contents
Advertisement
Clamping the axes
Feed-rate enable
December 2001
After running an NC block you can clamp the axes:
7 7 7 7
Wait until "axis in position" is set in W1026.
7 7 7 7
Clamp the axis or axes.
7 7 7 7
Open the position control loop with W1040.
7 7 7 7
With Module 9161, switch the drive off.
A waiting period is necessary between "axis clamping" and "position control
loop opening."
7 7 7 7
In W1038, set the bit for the corresponding axis.
The next NC block is not run until the positioning window has been reached
and the position control loop has been opened with W1040.
If the position control loop is opened, the axis release in W1024 is canceled.
You can link switching off the drives via Module 9161 with W1024.
If a clamped axis is to be repositioned, the NC cancels the "axis in position"
message in W1026:
7 7 7 7
With Module 9161, switch the drive on.
7 7 7 7
Release the clamping.
7 7 7 7
Close the position control loop with W1040.
W1038
Preparing opening of the position
control loop
Bits 0 to 8 correspond to axes 1 to 9
0: Not active
1: Active
W1040
Axis-specific opening of the position
control loop
Bits 0 to 8 correspond to axes 1 to 9
0: Do not open the position control loop
1: Open the position control loop
To move the axis, you must first enable the feed rate through the PLC. Until
"feed-rate enable" is set, the nominal velocity value zero is output. In the
status display, "F" is highlighted.
Feed-rate enable for all axes:
7 7 7 7
Set M4563.
Axis-specific feed-rate enable:
7 7 7 7
Reset M4563.
7 7 7 7
In W1060, set the corresponding bits.
M4563
Feed-rate enable for all axes
W1060
Axis-specific feed-rate enable
Bits 0 to 8 correspond to axes 1 to 9
0: No feed-rate enable
1: Feed-rate enable
The Control Loop
Set
Reset
PLC
PLC
PLC
PLC
Set
Reset
PLC
PLC
PLC
PLC
6 – 131
Advertisement
Table of Contents
