HEIDENHAIN TNC 426 PB/M Technical Manual page 308

MP Function and input
MP7682 Machine parameter with multiple function
Format:
Input:
MP7683 Pallet tables, executing
Format:
Input:
4 – 70
%xxx
Bit 0 – Incremental block after TOOL CALL
0: With length compensation
1: Without length compensation
Bit 1 – Reference value for calculating the preset
during datum setting
0: Actual value is calculated
1: Nominal value is calculated
Bit 2 – Traverse path of rotary axes with
modulo display
0: Positioning without passing over zero
1: Positioning on the shortest path
Bit 3 - Reserved, enter 0
Bit 4 – Tolerance of rotary axes with M128
0: With consideration of head dimensions
1: Without consideration of head dimensions
%xxxxx
Bit 0 – Operating mode PROGRAM RUN,
SINGLE BLOCK
0: During the start, a line of the NC program
is run. The pallet change macro is
executed completely.
1: During the start, a complete NC program
is run.
Bit 1 – Operating mode PROGRAM RUN,
FULL SEQUENCE
0: During the start, a complete NC program
is run.
1: At the start all NC programs are executed up
to the next pallet.
Bit 2 – PROGRAM RUN, FULL SEQUENCE
operating mode
0: As defined in bit 1
1: All NC programs and pallets up to the
end of the table are executed.
Bit 3 – When the end of the pallet table is
reached, the process begins again with
the first line
0: Function is not in effect
1: Function is in effect (bit 2 = 1)
Bit 4 – Editing the active pallet table
0: Active pallet table cannot
be edited
1: In the operating modes PROGRAM RUN,
FULL SEQUENCE and PROGRAM RUN,
SINGLE BLOCK, the active pallet table can
be edited
HEIDENHAIN Technical Manual TNC 426, TNC 430
Software Page
version and
behavior
PLC 6 – 82,
6 – 119,
RUN
6 – 231,
6 – 232,
PLC 6 – 247,
6 – 306
RUN