Module 9182 Re-Enabling Individual Nc Keys; Module 9183 Disabling Groups Of Nc Keys - HEIDENHAIN TNC 426 PB/M Technical Manual

6 – 340

Module 9182 Re-enabling individual NC keys

With this module you cancel the effect of Module 9181.
Call:
PS B/W/D/K <Key code>
CM 9182
PL B/W/D <Error status>
0: NC key enabled
-1: For error see W1022
Error recognition:
Marker Value Meaning
M4203 0 Disabling was cancelled
1 Error code in W1022
W1022 1 Transferred parameter > maximum value
2 Transferred parameter invalid

Module 9183 Disabling groups of NC keys

The key-group codes are:
n
0: All keys
n
1: ASCII
n
2: Soft keys, Page Up/Down
n
3: Cursor, ENT, NOENT, DEL, END, GOTO
n
4: Numbers, algebraic signs, decimal point, actual position capture
n
5: Operating modes
n
6: Block opening keys
Call:
PS B/W/D/K <Key group code>
CM 9183
PL B/W/D <Error status>
0: Group of NC keys disabled
–1: Transferred value> maximum value
Error recognition:
Marker Value Meaning
M4203 0 The group of NC keys was disabled
1 Error code in W1022
W1022 2 Transferred parameter invalid
HEIDENHAIN Technical Manual TNC 426, TNC 430