Nc Software 280 472-Xx And 280 473-Xx - HEIDENHAIN TNC 426 PB/M Technical Manual

2.6.2 NC Software 280 472-xx and 280 473-xx

NC software
280 472-01 (export
version 280 473-01)
December 2001
Release: 04/97
Improvements:
n
New function "Fast contour milling": Cycle 32 or G62 and MP1096
n
Automatic calculation of cutting data
n
TCPM (Tool Center Point Management): With M128 you can superimpose
manual axial machine movements during program run, whereby the offsets
of the tilting axes are automatically compensated.
n
Additional information with the HELP key
n
Input menu for fixed input values is selected with the GOTO key.
n
New pallet management
n
Freely definable tables
n
NC blocks can be transferred in spline format.
n
More memory on the hard disk (1.5 GB)
n
The MOD function PGM MGT enables the user to choose between
standard and extended file management.
n
In the status display the positions of all nine axes are shown. The spindle
position overwrites the ninth axis.
n
The progress of the copying process is shown in a pop-up window.
n
The number of Q parameters was increased from 299 to 399.
n
Q parameters are also permitted in FK blocks
n
M110 is also effective in the contour pocket cycle
n
Cycle 204: Back boring
n
With MP7682 bit 2 you can define whether rotary axes should always be
positioned by the shortest path.
n
It is now possible to enter a chamfering feed rate in an NC block for
chamfering (CHF).
n
Cycle 19 "Working plane" has been extended with parameters for feed rate
and safety clearance. (This applies only if the cycle positions tilted axes,
which is defined in MP7500.)
n
M114 can also be used with non-controlled axes or PLC axes.
n
Hungarian conversational language added
n
All soft keys appear in the defined conversational language.
n
Language-dependent soft keys for OEM cycles
n
The soft keys for FK programming do not appear until you have pressed the
FK key.
n
Soft key F for feed rate in the manual operating modes
n
New soft key: JOG INCREMENT OFF/ON
n
New soft key: HIDE TOOLS OFF/ON: In the tool table, only the tools in the
tool magazine are displayed
n
New soft keys for copying fields in the tool table
n
PLC soft keys can be appended to NC soft-key rows.
n
Ethernet: It is possible to enter the name of a network printer.
n
The probe results of the manual probing function can be transferred
immediately to the datum tables.
n
MP6170, MP6171: multiple measurement with measuring tolerance
n
Separate set of calibration data for TS and TT for every traverse range
Software Releases 2 – 45