HEIDENHAIN TNC 426 PB/M Technical Manual page 58

NC software
280 472-05 (export
version 280 473-05)
NC software
280 472-06 (export
version 280 473-06)
NC software
280 472-07 (export
version 280 473-07)
2 – 48
Release: 11/97
Improvements:
n
Maximum spindle speed without spindle DSP was increased to 12 000 rpm.
n
Maximum spindle speed with spindle DSP was increased to 24 000 rpm.
n
MP6180.x, MP6181.x, MP6182.x: Approximate position of ring gauge
center for probing cycle CALIBRATE TS
n
MP6185: Distance below top surface for probing during calibration
n
MP7471: Maximum speed of the linear axes for compensatory traverse by
positioning the angular axes with M128.
n
FN18: ID505 Datum table selected?
n
FN18: ID1010 Does MP exist?
n
Module 9135: Switch on infrared probe
n
D364: Nominal speed new
n
D368: Actual speed new
n
Language-dependent text blocks in the print masks of the probing cycles
n
New code word: LOGBOOK
Release: 12/97
Improvements:
n
FN17: ID990 NR2 Switch sensor monitoring on or off
n
FN17: ID990 NR3 Transfer sensor data to tool table
n
FN17: ID990 NR4 Coordinate transformation
n
New timers T96 to T143
n
M4065: All workpiece dimensions are OK
n
M4066: Workpiece must be remachined
n
M4067: Workpiece to be scrapped
n
New touch probe cycles
Release: 02/98
Improvements:
n
MP2180: PWM frequency
n
MP6500 bit 12: Consider PLC datum shift during tool measurement
n
MP6120, MP6350, MP6360, MP6520: Minimum input value reduced to 1
n
MP7260: Maximum input value reduced to 30 000
n
MP7683 bit 3: Behavior at reaching end of pallet table
n
FN18 ID50: Read data from tool table
n
FN18 ID220 NR2: Read current datum shift
n
FN18 ID220 NR4: Read current PLC datum shift
n
Module 9008: Read certain inputs of PLC input/output unit
n
Module 9009: Set certain outputs of PLC input/output unit
n
Module 9145: Automatic actual and nominal value transfer
HEIDENHAIN Technical Manual TNC 426, TNC 430