Table of Contents
Advertisement
1 Update Information No. 6
1.1 Releases
1.2 NC software 280 474-xx
1.3 NC software 280 476-xx
Machine
parameters
Machine
integration
December 2001
The following NC software was released:
n
NC software 280 474-18 and 280 475-18
n
NC software 280 474-19 and 280 475-19
n
NC software 280 476-15 and 280 477-15
n
NC software 280 476-16 and 280 477-16
n
NC software 280 476-17 and 280 477-17
n
NC software 280 476-18 and 280 477-18
n
NC software 280 476-19 and 280 477-19
n
NC software 280 476-20 and 280 477-20
n
NC software 280 476-21 and 280 476-21
NC software Setup Disks
280 474-18
286 195-21
Export version:
280 475-18
286 195-21
NC Software Setup Disks
280 474-19
286 195-22
Export version:
280 475-19
286 195-22
NC software Setup Disks
280 476-15
286 197-17
Export version:
280 477-15
286 197-17
n
MP7441 has been expanded:
Bit 1: Reserved, enter 0
Bit 2: Error message "Enter depth as negative" when a positive depth was
programmed in the fixed cycles.
= 0: Error message is suppressed
= 1: Error message is not suppressed
n
MP7682 has been expanded:
Bit 3: Reserved, enter 0
Bit 4: Reserved, enter 0
n
Before a probing block, the control checks whether M4501 is set. If it is, the
probing block start is delayed by 1 second.
Update Information No. 6
June 2001
August 2001
November 2000
December 2000
March 2001
April 2001
July 2001
August 2001
November 2001
Release
06/2001
06/2001
Release
08/2001
08/2001
Release
11/2000
11/2000
1 – 1
Advertisement
Table of Contents
