7.5.2.5
no ip dhcp relay information option
Description
With this command, you disable the "IP DHCP Relay Information" option.
Requirement
You are in the Global configuration mode or in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay information option
Result
The option is disabled.
Further notes
You enable the option with the
You can display the status of this option and other information with the
information
7.5.2.6
service dhcp-relay
Description
With this command, you enable the DHCP relay agent on the device. The DHCP relay agent
forwards the DHCP query to DHCP servers located in a different subnet.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
service dhcp-relay
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli(config-if-$$)#
ip dhcp relay information option
command.
Network protocols
7.5 DHCPv4 Relay Agent (IPv4)
command.
show ip dhcp relay
327