Viewing A List Of Ip Pools; Adding An Ip Pool - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.15.13.1

Viewing a List of IP Pools

To view a list of IP pools configured for a DHCP subnet, navigate to services » dhcpserver » subnet »
{name} » options » ippool, where {name} is the name of the subnet. If pools have been configured, the IP Pool
Configuration table appears.
Figure 379: IP Pool Configuration Table
If no IP pools have been configured, add pools as needed. For more information, refer to
"Adding an IP Pool".
Section 5.15.13.2

Adding an IP Pool

To add an IP pool to a DHCP subnet, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver » subnet » {name} » options » ippool, where {name} is the name of
the subnet.
3. Click <Add ippool>. The Key Settings form appears.
Figure 380: Key Settings Form
1. Description Box
4. Configure the following parameter(s) as required:
Parameter
description
5. Click Add to create the IP pool. The Leased Configuration and IP Pool Configuration forms appear.
Viewing a List of IP Pools
1
2. Add Button
Description
Describes the IP pool.
Chapter 5
Setup and Configuration
Section 5.15.13.2,
2
351