Sbus<N>:Mode - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:SBUS<n>:MODE
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {A429 | FLEXray | CAN | I2S | IIC | LIN | M1553 | SPI
The :SBUS<n>:MODE command determines the decode mode for the serial
bus.
This command is only valid when a serial decode option has been licensed.
N O T E
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {A429 | FLEX | CAN | I2S | IIC | LIN | M1553 | SPI | UART
Errors
•
See Also •
•
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
| UART | USB}
| USB| NONE}
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:A429 Commands"
":SBUS<n>:CAN Commands"
":SBUS<n>:FLEXray Commands"
":SBUS<n>:I2S Commands"
":SBUS<n>:IIC Commands"
":SBUS<n>:LIN Commands"
":SBUS<n>:M1553 Commands"
":SBUS<n>:SPI Commands"
":SBUS<n>:UART Commands"
":SBUS<n>:USB Commands"
on page 1169
on page 645
on page 650
on page 668
on page 685
on page 704
on page 723
on page 733
on page 747
on page 754
on page 770
on page 792
28
:SBUS<n> Commands
649