Sbus<N>:Mode - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

:SBUS<n>:MODE
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {CAN | IIC | LIN | SPI | UART}
The :SBUS<n>:MODE command determines the decode mode for the serial
bus.
This command is only valid when a serial decode option has been licensed.
N O T E
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {CAN | IIC | LIN | SPI | UART | NONE}
Errors
•
See Also •
•
•
•
•
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
(see page 790)
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:CAN Commands"
":SBUS<n>:IIC Commands"
":SBUS<n>:LIN Commands"
":SBUS<n>:SPI Commands"
":SBUS<n>:UART Commands"
on page 753
on page 447
on page 452
on page 469
on page 479
on page 493
on page 509
25
:SBUS<n> Commands
451