Chrysler 2005 Crossfire SRT6 Service Manual page 374

5 - 208 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1130-RIGHT REAR WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE OF THE RIGHT REAR WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Measure the resistance between ground and the Right Rear Wheel
Speed Sensor Signal circuit.
Is the resistance greater than 300 ohms?
Yes >> Go to 10
No >> Replace the Right Rear Wheel Speed Sensor. (Refer to 5
- BRAKES/ELECTRICAL/REAR WHEEL SPEED SENSOR
- REMOVAL).
Perform ABS VERIFICATION TEST.
10.
MEASURE THE RESISTANCE OF THE RIGHT REAR WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Right Rear Wheel Speed Sensor
Signal circuit from the CAB harness connector to the Right Rear
Wheel Speed Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 12
No >> Repair the Right Rear Wheel Speed Sensor Signal
circuit for an open.
Perform ABS VERIFICATION TEST.
ZH