Chrysler 2005 Crossfire SRT6 Service Manual page 371

ZH
1130-RIGHT REAR WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
2.
INSPECT THE RIGHT REAR WHEEL SPEED SENSOR
Turn the ignition off.
Inspect the Right Rear Wheel Speed Sensor and connector.
Is the Sensor or Connector damaged?
Yes >> Repair as necessary.
Perform ABS VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE VOLTAGE OF THE RIGHT REAR WHEEL SPEED SENSOR 12 VOLT SUPPLY CIRCUIT
With the ignition off.
Disconnect the Right Rear Wheel Speed Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Right Rear Wheel Speed Sensor 12 Volt
Supply circuit at the Right Rear Wheel Speed Sensor harness connec-
tor.
Is the voltage above 10 volts?
Yes >> Go to 8
No >> Go to 4
4.
MEASURE THE VOLTAGE OF THE RIGHT REAR WHEEL SPEED SENSOR 12 VOLT SUPPLY CIRCUIT
Turn the ignition off.
Measure the voltage of the Right Rear Wheel Speed Sensor 12 Volt
Supply circuit at the Right Rear Wheel Speed Sensor harness connec-
tor.
Is the voltage below 1.0 volt?
Yes >> Go to 6
No >> Go to 5
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 205