Dell Z9500 Reference Manual page 1849

Hide thumbs Also See for Z9500:

Table of Contents

virtual-address

Virtual Router Redundancy Protocol (VRRP)

When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the

same as the VRID number configured with the vrrp-group or vrrp-ipv6-

group command.

When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to

16 times the vrrp-group or vrrp-ipv6-group vrid number plus the ip

vrf vrf-id number. For example, if VRF microcode is loaded and VRRP group

10 is configured in VRF 2, the VRID used for the VRRP group is (16 x 10) + 2, or

162. This VRID value is used in the lowest byte of the virtual MAC address of the

VRRP group and is also used for VRF routing.

NOTE: Configure the same VRID on neighboring routers (Dell Networking or

non-Dell Networking) in the same VRRP group in order for all routers to

interoperate.

— assigns up to 12 virtual IP addresses per VRRP group.