Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Default Configuration
No addresses are defined.
Command Mode
Interface Configuration (Ethernet, port-channel) mode. It cannot be
configured for a range of interfaces (range context).
User Guidelines
This command enables adding secure MAC addresses to a routed port in port
security mode. The command is available when the port is a routed port and
in port security mode. The address is deleted if the port exits the security
mode or is not a routed port.
This command is required because the bridge address command cannot be
executed on internal VLANs.
Example
The following example adds the MAC-layer address 66:66:66:66:66:66 to
gigabitethernet port 1/0/1.
Console(config)#
Console(config-if)#
66:66:66:66:66:66
show mac address-table
Use the show mac address-table EXEC command to view entries in the MAC
address table.
Syntax
show mac address-table
interface-id] [address mac-address]
Parameters
•
dynamic—Displays only dynamic MAC address table entries.
•
static—Displays only static MAC address table entries.
•
secure—Displays only secure MAC address table entries.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\Address_Table.fm
gigabitethernet 1/0/1
interface
port security routed secure-address
[dynamic | static| secure] [vlan vlan] [interface
Address Table Commands
399
Advertisement
Table of Contents
