Show Power Inline - Cisco 220 Series Smart Plus Reference Manual

Power over Ethernet (PoE) Commands

show power inline

show power inline
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
-------- -------- ---------------- ---------------- ----------------
1 GREEN 30
2 GREEN 38
To show the inline power settings for all interfaces or for a specific interface, use
the show power inline Privileged EXEC mode command.
Syntax
show power inline [interfaces
Parameters
interface-id
• interfaces
list of Ethernet interface IDs.
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Example
Example 1—The following example shows the inline power settings for all
interfaces:
switchxxxxxx# show power inline
Power management mode: Port limit mode
Legacy device supports: enabled
Unit Power Status Nominal
Power
---- ----- ------ -------- --------------- -------- --------- --------- -----
--
1 Off Normal 375Watts
Port State Status
---- ----- ---------- -------- ------- ----------------- ----------------
gi1 Auto searching low
gi2 Auto searching low
gi3 Auto searching low
48
49
interface-id
]
—(Optional) Specifies an Ethernet interface ID or a
Allocated
Power
0Watts (0%)
Priority Class Max.Power (Admin) Device
(mW)
N/A 30000 (30000)
N/A 30000 (30000)
N/A 30000 (30000)
54
55
Consumed Available Usage
Power Power Threshold
0Watts 375Watts 95
N/A
N/A
N/A
25
Traps
enabled
364