Lldp Reinit - Cisco 220 Series Smart Plus Reference Manual

LLDP Commands

lldp reinit

lldp reinit
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
no lldp receive
Parameters
N/A
Default Configuration
Enabled
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP data received through the LAG ports
is stored individually per port.
LLDP operation on a port is not dependent on the STP state of a port. For example,
LLDP frames are received on the blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# lldp receive
To specify the minimum time that an LLDP-enabled port waits before reinitializing
the LLDP transmission, use the lldp reinit Global Configuration mode command.
To revert to its default settings, use the no form of this command.
Syntax
seconds
lldp reinit
no lldp reinit
Parameters
seconds
• —The minimum time in seconds that a LLDP port waits before
reinitializing the LLDP transmission. (Range: 1 to 10)
22
327