Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
power inline legacy enable
power inline legacy enable
power inline limit
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable supporting legacy powered devices, use the power inline legacy
enable Global Configuration mode command.
To disable supporting legacy powered devices, use the no form of this command.
Syntax
power inline legacy enable
no power inline legacy enable
Default Configuration
Power inline legacy is disabled.
Command Mode
Global Configuration mode
User Guidelines
This feature only works when establishing the autonegotiation connection. For the
legacy powered devices that are already connected, disabling this feature only
takes effect after you unplug their cables.
Example
switchxxxxxx(config)# power inline legacy enable
To limit the power consumption on an interface, use the power inline limit Interface
Configuration mode command.
To revert to its default setting, use the no form of the command.
Syntax
power
power inline limit
no power inline limit
25
359
Advertisement
Table of Contents
