Cisco 220 Series Smart Plus Reference Manual page 88

ACL Commands
show access-lists
show access-lists
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
• ip | ipv6 | mac—Specifies the ACL type.
acl-name
• —(Optional) Name of the ACL. (Range: 1 to 32 characters)
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show ip access-lists
To display all ACLs configured on the switch, use the show access-lists Privileged
EXEC mode command.
Syntax
show access-lists
Parameters
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show access-lists
MAC access list macacl1
sequence 1 permit any any cos 7 5
IPv6 access list v6acl1
sequence 1 permit ipv6 abcd::/64 aacc::/64
4
86