Show Lldp - Cisco 220 Series Smart Plus Reference Manual

LLDP Commands

show lldp

show lldp
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
The tx-delay cannot be larger than 0.25 of the LLDP transmission interval.
Example
switchxxxxxx(config)# lldp timer 30
To show the LLDP status, use the show lldp Privileged EXEC mode command.
Syntax
show lldp
Parameters
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show lldp
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
LLDP packet handling: Flooding
Port | State | Optional TLVs
-------- + ------ + -------------- + --------
gi1 | RX,TX |
gi2 | RX,TX |
gi3 | RX,TX |
gi4 | RX,TX |
gi5 | RX,TX |
gi6 | RX,TX |
gi7 | RX,TX |
gi8 | RX,TX |
gi9 | RX,TX |
gi10 | RX,TX |
gi11 | RX,TX |
| Address
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
SN, SC |192.168.1.254
22
333