Trust-Shape (Interface) - Cisco 220 Series Smart Plus Reference Manual

QoS Commands

trust-shape (Interface)

trust-shape (Interface)
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config)# traffic-shape burst queue 9600
To configure the egress port shaper, use trust-shape Interface Configuration mode
command. The egress port shaper controls the traffic transmit rate (Tx rate).
To disable the shaper, use the no form of this command.
Syntax
committed-rate
traffic-shape
no traffic-shape
Parameters
committed-rate
•
(kbps). (Range: 16 to 1000000 kbps)
Default Configuration
The shaper is disabled.
Command Mode
Interface Configuration (Ethernet, port channel) mode
Example
The following example sets a traffic shaper on fa5 when the average traffic rate
exceeds 124000 kbps:
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# traffic-shape 124000
—The maximum average traffic rate in 16 kbits per second
28
410