Table of Contents
Advertisement
QoS Commands
qos remark
qos remark
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
queue-list
•
—Up to eight queue numbers to map to the specified IP
precedence value. (Range:1 to 8)
ip-precedence-id
•
to
values are mapped.
Default Configuration
Queue-to-precedence mapping matrix
Queue
1
IP Precedence
0
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# qos map queue-precedence 8 to 7
To configure the remarking state of each interface, use the qos remark Interface
Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
qos remark {cos | dscp | ip-precedence}
no qos remark {cos | dscp | ip-precedence}
Parameters
•
cos—Remarks the ingress packets with the CoS value.
•
dscp—Remarks the ingress packets with the DSCP value.
•
ip-precedence—Remarks the ingress packets with the IP precedence
value.
—Specifies the precedence value to which the queue
2
3
4
5
1
2
3
4
28
6
7
8
5
6
7
397
Advertisement
Table of Contents
