Table of Contents
Advertisement
QoS Commands
police aggregate
police aggregate
NOTE
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
committed-rate-kbps
•
(kbps). (Range: 16 to 10000000)
•
exceed-action {drop | forward}—(Optional) Specifies the action to be taken
when the rate is exceeded. The possible values are:
-
drop—Drops the packet.
-
forward—Forwards the packet.
Default Usage
N/A
Command Mode
Policy-map Class Configuration mode
User Guidelines
Policing uses a token bucket algorithm. CIR represents the speed with which the
token is added to the bucket.
Example
The following example defines a policer for classified traffic. When the traffic rate
exceeds 124,000 kbps, the packet is dropped. The class is called class1 and is in
a policy map called policy1.
switchxxxxxx(config)# policy-map policy1
switchxxxxxx(config-pmap)# class class1
switchxxxxxx(config-pmap-c)# police 124000 exceed-action drop
To apply an aggregate policer to multiple class maps within the same policy map,
use the police aggregate Policy-map Class Configuration mode command.
To remove an existing aggregate policer from a policy map, use the no form of this
command.
This command is available only when the switch is in QoS advanced mode.
—The average traffic rate (CIR) in kbits per second
28
384
Advertisement
Table of Contents
