Management Vlan Ip Dhcp Client - Cisco 220 Series Smart Plus Reference Manual

IP Addressing Commands

management vlan ip dhcp client

management vlan ip dhcp client
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To acquire an IP address for the management VLAN from the DHCP server, use the
management vlan ip dhcp client Global Configuration mode command.
To release an acquired IP address, use the no form of this command.
Syntax
management vlan ip dhcp client
no management vlan ip dhcp client
Parameters
N/A
Default Configuration
DHCP client is enabled.
Command Mode
Global Configuration mode
User Guidelines
This command enables the switch to dynamically learn its IP address by using the
DHCP protocol.
DHCP client configuration on the switch implicitly removes the static IP address
configuration on the management VLAN.
If the switch is configured to obtain its IP address from a DHCP server, it sends a
DHCPDISCOVER message to provide information about itself to the DHCP server
on the network.
The no management vlan ip dhcp client command releases any IP address that
was acquired, and sends a DHCPRELEASE message.
Example
switchxxxxxx(config)# management vlan ip dhcp client
14
232