Show Ip Arp Inspection Interfaces - Cisco 220 Series Smart Plus Reference Manual

Smart plus switches command line interface
Hide thumbs Also See for 220 Series Smart Plus:
Table of Contents

Advertisement

IP ARP Inspection Commands

show ip arp inspection interfaces

show ip arp inspection interfaces
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Field
Source Mac Validation
Destination Mac
Validation
IP Address Validation
Enable on Vlans
To show the ARP Inspection configuration for specific interfaces, use the show ip
arp inspection interfaces Privileged EXEC mode command.
Syntax
show ip arp inspection interfaces
Parameters
interface-id—
Specifies an interface ID or a list of interface IDs. The
interfaces can be one of these types: Ethernet port or port channel.
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show ip arp inspection interfaces gi1
Interfaces | Trust State |
------------+-------------+-------------
gi1
| Untrusted
Description
Shows whether to compare the source MAC address
in the Ethernet header against the sender MAC
address in ARP body.
Shows whether to compare the destination MAC
address in the Ethernet header against the target MAC
address in ARP body.
Shows whether to compare the ARP body for invalid
and unexpected IP addresses.
Shows whether dynamic ARP Inspection is enabled or
disabled on the VLANs.
interface-id
Rate (pps)
|
15
15
243

Advertisement

Table of Contents
loading

Table of Contents