Table of Contents
Advertisement
Ethernet Configuration Commands
storm-control ifg
storm-control ifg
storm-control unit
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To set the interframe configuration of storm control counting, use the storm-control
ifg Global Configuration command.
Syntax
storm-control ifg {include | exclude}
Parameters
•
include—Includes preamble and IFG.
•
exclude—Excludes preamble and IFG.
Default Configuration
Exclude
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# storm-control ifg include
To set the unit of storm control counting, use the storm-control unit Global
Configuration command.
Syntax
storm-control unit {bps | pps}
Parameters
•
bps—Specifies the unit as bits per second.
•
pps—Specifies the unit as packets per second.
Default Configuration
The default is bps.
11
173
Advertisement
Table of Contents
