Table of Contents
Advertisement
Ethernet Configuration Commands
errdisable recovery
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Syntax
errdisable recovery {cause {all | acl | arp-inspection | bpduguard | broadcast-flood |
dhcp-rate-limit | psecure-violation | selfloop | unicast-flood | unknown-multicast-
interval
flood} | interval
no errdisable recovery cause {all | acl | arp-inspection | bpduguard | broadcast-
flood | dhcp-rate-limit | psecure-violation | selfloop | unicast-flood | unknown-
multicast-flood}
Parameters
•
cause—Enables errdisable recovery from a specific cause. The available
options are:
-
all—Enables the timer to recover from all causes.
-
acl—Enables the timer to recover from the ACL causes.
-
arp-inspection—Enables the timer to recover from the ARP inspection
causes.
-
bpduguard—Enables the timer to recover from the BPDU Guard causes.
-
broadcast-flood—Enables the timer to recover from the flood causes.
-
dhcp-rate-limit—Enables the timer to recover from the DHCP rate limit
causes.
-
psecure-violation—Enables the timer to recover from the port security
causes.
-
selfloop—Enables the timer to recover from the self-loop causes.
-
unicast-flood—Enables the timer to recover from the unicast flood
causes.
-
unknown-multicast-flood—Enables the timer to recover from the
unknown multicast flood causes.
interval
•
interval
state. The same interval is applied to all causes. (Range: 30 to 86400
seconds, default: 300 seconds)
Default Configuration
Errdisable recovery is disabled for all causes.
}
—Specifies the time to recover from a specific error-disable
11
159
Advertisement
Table of Contents
