Table of Contents
Advertisement
802.1X Commands
dot1x system-auth-control
dot1x system-auth-control
dot1x timeout quiet-period
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable 802.1X globally on the switch, use the dot1x system-auth-control Global
Configuration mode command.
To disable 802.1X globally on the switch, use the no form of this command.
Syntax
dot1x system-auth-control
no dot1x system-auth-control
Parameters
N/A
Default Configuration
802.1X is disabled.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# dot1x system-auth-control
To set the time interval that the switch remains in a quiet state following a failed
authentication exchange (for example, the client provided an invalid password),
use the dot1x timeout quiet-period Interface Configuration (Ethernet) mode
command.
To revert to its default setting, use the no form of this command.
Syntax
dot1x timeout quiet-period
no dot1x timeout quiet-period
seconds
2
41
Advertisement
Table of Contents
