Voice Vlan Oui-Table - Cisco 220 Series Smart Plus Reference Manual

Voice VLAN Commands

voice vlan oui-table

voice vlan oui-table
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
• auto—Specifies that the port is identified as a candidate to join the voice
VLAN. When a packet with a source OUI MAC address that identifies the
remote equipment as voice equipment is seen on the port, the port joins the
voice VLAN as a tagged port. If the time since the last telephony MAC
address was aged out of the MAC address table exceeds the voice VLAN
aging time, the port is removed from the voice VLAN.
• manual—Specifies that the port is manually assigned to the voice VLAN.
Default Configuration
The default mode is auto.
Command Mode
Interface Configuration mode
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# voice vlan mode manual
To configure the voice VLAN OUI table, use the voice vlan oui-table Global
Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
voice vlan oui-table {add
description
[ ]
no voice vlan oui-table
Parameters
mac-address-prefix
• add
voice VLAN OUI table.
• remove mac-address-prefix
from the voice VLAN OUI table.
mac-address-prefix
| remove
—Adds the specified MAC address prefix to the
—Removes the specified MAC prefix address
40
mac-address-prefix
}
496