Table of Contents
Advertisement
Ethernet Configuration Commands
interface range
interface range
jumbo-frame
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To execute a command on multiple interfaces simultaneously, use the interface
range command.
Syntax
interface-list
interface range
Parameters
•
interface-list
—A list of interface IDs. The interface ID can be one of these
types: Ethernet port, VLAN, or port channel.
Default Configuration
N/A
Command Mode
Interface Configuration (Ethernet, port channel, or VLAN) mode
User Guidelines
The commands under the interface range are executed independently on each
interface in the range. If the command returns an error on one of the interfaces, it
does not stop the execution of the command on other interfaces.
Example
switchxxxxxx(config)# interface range gi1-20
switchxxxxxx(config-if-range)#
To enable jumbo frames on the switch and set the maximum frame size supported
by the switch, use the jumbo-frame Global Configuration mode command.
To disable jumbo frames on the switch, use the no form of this command.
Syntax
frame-size
jumbo-frame
11
162
Advertisement
Table of Contents
