Switchport Vlan Tpid; Vlan - Cisco 220 Series Smart Plus Reference Manual

VLAN Commands

switchport vlan tpid

switchport vlan tpid

vlan

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config-if)# switchport trunk native vlan 2
To set the Modified Tag Protocol Identifier (TPID) for an interface, use the
switchport vlan tpid Interface Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
switchport vlan tpid {
Parameters
0x8100
• —The TPID is 0x8100.
0x88A8
• —The TPID is 0x88A8.
0x9100
• —The TPID is 0x9100.
0x9200
• —The TPID is 0x9200.
Default Configuration
The default TPID is 0x8100.
Command Mode
Interface Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# switchport vlan tpid 0x88A8
To create a VLAN or a list of VLANs, use the vlan Global Configuration mode
command.
To delete the VLANs, use the no form of this command.
0x8100 0x88A8 0x9100
| |
0x9200
| }
41
522