Privileged Exec Mode; Global Configuration Mode - Cisco 220 Series Smart Plus Reference Manual

Smart plus switches command line interface
Hide thumbs Also See for 220 Series Smart Plus:
Table of Contents

Advertisement

Introduction
CLI Command Modes
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x

Privileged EXEC Mode

A user with level 15 automatically logs into the Privileged EXEC mode.
The user-level prompt consists of the switch hostname followed by a #. The
default hostname is switchxxxxxx where xxxxxx is the last six digits of the
switch's MAC address, as shown here:
switchxxxxxx#
Users with level 1 can enter the Privileged EXEC mode by entering the enable
command, and when prompted, the password for level 15.
To return from the Privileged EXEC mode to the User EXEC mode, use the disable
command.

Global Configuration Mode

The Global Configuration mode is used to run the commands that configure the
features at the system level, as opposed to the interface level.
Only users with command level 15 can access this mode.
To access the Global Configuration mode from the Privileged EXEC mode, enter
the configure command at the Privileged EXEC mode prompt and press Enter. The
Global Configuration mode prompt, consisting of the switch hostname followed by
(config)#, is displayed:
switchxxxxxx(config)#
Use any of the following commands to return from the Global Configuration mode
to the Privileged EXEC mode:
exit
end
Ctrl+Z
The following example shows how to access the Global Configuration mode and
return to the Privileged EXEC mode:
switchxxxxxx#
switchxxxxxx# configure
switchxxxxxx(config)# exit
switchxxxxxx#
1
25

Advertisement

Table of Contents
loading

Table of Contents