Table of Contents
Advertisement
TACACS+ Commands
tacacs-server host
tacacs-server host
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
User Guidelines
The switch can be configured to use this default key or to use a key for an
individual server. If you set a default key and a key string for an individual
TACACS+ server, the key string configured for the individual TACACS+ server
takes precedence.
Example
The following example sets accounting12345 as the authentication and encryption
key for all TACACS+ servers:
switchxxxxxx(config)# tacacs-server default-param key accounting12345
To define a TACACS+ host, use the tacacs-server host Global Configuration mode
command.
To delete a TACACS+ host, use the no form of this command.
Syntax
ip-address
tacacs-server host {
priority
[priority
] [timeout
no tacacs-server host {
Parameters
•
ip-address
—IP address of the TACACS+ server.
hostname
•
—Hostname of the TACACS+ server.
key-string
•
key
for all TACACS+ communications between the switch and the TACACS+
server. This key must match the encryption used on the TACACS+ daemon.
To specify an empty string, enter "".
port-number
•
port
which the TACACS+ session occurs. If the port number is set to 0, the host
is not used for authentication. (Range: 0 to 65535, default: 49)
hostname
|
timeout
]
ip-address
hostname
|
—(Optional) Specifies the authentication and encryption key
—(Optional) Specifies the TCP port number through
key-string
} [key
] [port
}
37
port-number
]
464
Advertisement
Table of Contents
