Cisco 220 Series Smart Plus Reference Manual page 309

LACP Commands
show lacp
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx# show lacp internal
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode
Channel group 1
Port Flags State
fa1 SA bndl
fa2 SA down
Channel group 2
Port Flags State
fa3 SA bndl
fa4 SA down
The following table describes the significant fields shown in the example:
Field
State
LACP Port Priority
LACP port Admin
Priority Key
1 0x3e8
1 0x3e8
LACP port Admin
Priority Key
1 0x3e9
1 0x3e9
Description
State of the specific port. The available values are:
—
• bndl Port is attached to an aggregator and
bundled with other ports.
—
• susp Port is in a suspended state; it is not
attached to any aggregator.
—
• hot-sby Port is in a hot-standby state.
—
• 1indiv Port is incapable of bundling with any
other port.
—
• 1indep Port is in an independent state (not
bundled but able to switch data traffic. In this
case, LACP is not running on the partner port).
—
• down Port is down.
Port priority setting. LACP uses the port priority to put
ports in standby mode when there is a hardware
limitation that prevents all compatible ports from
aggregating.
P - Device is in Passive mode
Oper Port
Key Number
0x3e8 0x1
0x3e8 0x2
Oper Port
Key Number
0x3e9 0x3
0x3e9 0x4
20
Port
State
0x3d
0x45
Port
State
0x3d
0x45
307