Lldp Tlv-Select Tlv; Lldp Transmit - Cisco 220 Series Smart Plus Reference Manual

LLDP Commands

lldp tlv-select TLV

lldp tlv-select TLV

lldp transmit

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To specify which optional TLVs are transmitted, use the lldp tlv-select TLV
Interface Configuration (Ethernet) mode command.
To remove all selected LLDP optional TLVs, use the no form of this command.
Syntax
TLV TLV
lldp tlv-select [
no lldp tlv-select
Parameters
TLV
• —(Optional) Available optional TLVs are port-desc, sys-name, sys-desc,
sys-cap, mac-phy, lag, max-frame-size, and management-addr.
Default Configuration
The sys-name and sys-cap TLVs are selected.
Command Mode
Interface Configuration mode
Example
switchxxxxxx(config)# interface gi20
switchxxxxxx(config-if)# lldp tlv-select port-desc sys-name sys-desc
To enable transmitting LLDP frames on an interface, use the lldp transmit Interface
Configuration mode command.
To stop transmitting LLDP frames on an interface, use the no form of this
command.
Syntax
lldp transmit
no lldp transmit
TLV TLV TLV TLV
] [ ] [ ] [ ] [
TLV TLV
] [ ] [ ]
22
330