Ethernet Configuration Commands
interface
interface
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enter the Interface Configuration mode in order to configure an interface, use
the interface Global Configuration mode command.
Syntax
interface-id
interface
Parameters
•
interface-id
—The interface ID can be one of these types: Ethernet port, port
channel, VLAN, range, IP interface, or tunnel.
Default Configuration
N/A
Command Mode
Interface Configuration (Ethernet, port channel, VLAN, Range) mode
Examples
Example 1—The following example enters the Interface Configuration mode in
order to configure a Gigabit Ethernet port:
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)#
Example 2—The following example enters the Interface Configuration mode in
order to configure a Fast Ethernet port:
switchxxxxxx(config)# interface fa1
switchxxxxxx(config-if)#
Example 3 - The following example enters the Interface Configuration mode in
order to configure a port channel (LAG):
switchxxxxxx(config)# interface po1
switchxxxxxx(config-if)#
11
161