Table of Contents
Advertisement
ACL Commands
ipv6 access-group in
ipv6 access-group in
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
An IPv4-based ACL is defined by a unique name. IPv4-based ACL, IPv6-based
ACL, MAC-based ACL, or policy map cannot have the same name.
Example
switchxxxxxx(config)# ip access-list extended server
switchxxxxxx(config-ip-acl)#
To bind an IPv6-based ACL to an interface, use the ipv6 access-group in Interface
Configuration mode command.
To remove all IPv6-based ACLs from an interface, use the no form of this
command.
Syntax
acl-name
ipv6 access-group
no ipv6 access-group in
Parameters
acl-name
•
—Name of the IPv6-based ACL. (Range: 1 to 32 characters)
Default Configuration
No IPv6-based ACL is applied to the interface.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# ipv6 access-group v6acl1 in
in
4
75
Advertisement
Table of Contents
