Management ACL Commands
no sequence (Management)
no sequence (Management)
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To remove a permit or deny condition (ACE) for a specific management ACL, use
the no sequence Management Access List Configuration mode command.
Syntax
no sequence
Parameters
N/A
Command Mode
Management Access List Configuration mode
Example
switchxxxxxx# show management access-list
2 management
access-lists are created
console-only
------------
sequence 1 deny interfaces fa1-24,gi1-2,po1-8 service all
! (Note: all other access implicitly denied)
mgmtacl1
--------
sequence 1 permit interfaces fa1 service telnet
! (Note: all other access implicitly denied)
switchxxxxxx# config
switchxxxxxx(config)# management access-list mgmtacl1
switchxxxxxx(config-macl)# no sequence 1
23
349