Table of Contents
Advertisement
IGMP Snooping Commands
ip igmp snooping vlan last-member-query-count
ip igmp snooping vlan last-member-query-count
ip igmp snooping vlan last-member-query-interval
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To configure the last member query counter on a VLAN, use the ip igmp snooping
vlan last-member-query-count Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
ip igmp snooping vlan
no ip igmp snooping vlan
Parameter
VLAN-LIST
•
—A VLAN ID or a list of VLAN IDs. (Range: 1 to 4094)
•
count
—The number of times that group-specific or group-source-specific
queries are sent upon receipt of a message indicating a leave. (Range: 1 to
7)
Default Configuration
2
Command Mode
Global Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
Example
switchxxxxxx(config-if)# ip igmp snooping vlan 3 last-member-query-count 7
To configure the last member query interval on a VLAN, use the ip igmp snooping
vlan last-member-query-interval Global Configuration mode command.
To revert to its default setting, use the no form of this command.
VLAN-LIST
last-member-query-count
VLAN-LIST
last-member-query-count
13
count
207
Advertisement
Table of Contents
