Table of Contents
Advertisement
CDP Commands
show cdp entry
show cdp entry
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
CDP log duplex mismatch is globally enabled
CDP log native VLAN mismatch is globally enabled
CDP log voice VLAN mismatch is globally enabled
Mandatory TLVs validation is enabled
Sending CDPv2 advertisements is enabled
Sending Appliance TLV is enabled
Device ID format is Host name
Sending CDP packets every 200 seconds
Sending a holdtime value of 180 seconds
CDP packets handling mode is flooding
To show information for all CDP neighbors or for a specific CDP neighbor, use the
show cdp entry Privileged EXEC mode command. You can limit the display to
protocol or version information.
Syntax
show cdp entry {* | WORD} [protocol | version]
Parameters
•
*—Displays information for all CDP neighbors.
•
WORD—Displays information for a specific CDP neighbor. You need to
specify the name of the CDP neighbor (its device ID) to be displayed.
•
protocol—(Optional) Displays information about the protocols enabled on
the CDP neighbors.
•
version—(Optional) Displays information about the software version running
on the CDP neighbors.
Command Mode
Privileged EXEC Mode
Example
switchxxxxxx# show cdp entry * protocol
7
115
Advertisement
Table of Contents
