Table of Contents
Advertisement
Port Channel Commands
channel-group
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To associate a port with a port channel, use the channel-group Interface
Configuration mode command.
To remove a port from a port channel, use the no form of this command.
Syntax
port channel
channel-group
no channel-group
Parameters
port channel
•
—The number of the port channel that the port will join.
•
mode—Specifies the mode of the port channel. The possible values are:
-
active—Enables LACP unconditionally. It forces unconditionally the port
to join a channel as a result of a LACP operation.
-
on—Enables static only. It forces the port to join a channel without a
LACP operation. In this mode, a usable EtherChannel exists only when
both connected port groups are in the on mode.
-
passive—Enables LACP only if a LACP device is detected. It forces the
port to join a channel as a result of a LACP operation. Active mode
places a port into a negotiating state in which the port initiates the
negotiations with other ports by sending LACP packets. A channel is
formed with another port group in either the active or passive mode.
Default Configuration
The port is not assigned to a port channel.
Command Mode
Interface Configuration (Ethernet) mode
mode {active | on | passive}
26
369
Advertisement
Table of Contents
