Permit (Management) - Cisco 220 Series Smart Plus Reference Manual

Management ACL Commands

permit (Management)

permit (Management)
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To set the permit rules (ACEs) for the management ACL, use the permit
Management Access-List Configuration mode command.
Syntax
sequence-number
[sequence
sequence-number
[sequence
address ipv6-prefix-length
/
Parameters
sequence-number
• sequence
for the ACL statement. The acceptable range is from 1 to 65535. If not
specified, the switch provides a number starting from 1 in ascending order.
interface-id
• interfaces
interface IDs. The interface can be one of these types: Ethernet port or port
channel.
service
• service
Telnet, SSH, HTTP, HTTPS, or SNMP.
ipv4-address/ipv4-mask
• ip
address.
ipv6-address/ipv6-prefix-length
• ipv6
and source IPv6 address prefix length. The prefix length must be preceded
by a forward slash (/). The parameter is optional.
Default Configuration
No rules are configured.
Command Mode
Management Access-List Configuration mode
User Guidelines
The rules with Ethernet, VLAN, and port channel parameters are valid only if an IP
address is defined on the appropriate interface.
Example
] permit interfaces
ipv4-address
] permit {ip
interface-id
} [interfaces
—(Optional) Specifies the sequence number
—(Optional) Specifies an interface ID or a list of
—Specifies the type of service. Possible values are all,
—Specifies the source IPv4 address and mask
interface-id
service
ipv4mask
/
service
] service
—Specifies the source IPv6 address
23
service
ipv6-
| ipv6
350