Cisco 220 Series Smart Plus Reference Manual page 460

SNMP Commands
snmp-server host
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Syntax
ipv4address
snmp-server host {
{1 | 2c | 3} [noauth | auth | priv]]
timeout-value
] [retries
no snmp-server host {
Parameters
ipv4address
• —IPv4 address of the host (the targeted recipient). The default
is all IP addresses.
hostname
• —Hostname of the host (the targeted recipient).
ipv6address
• —IPv6 address of the host (the targeted recipient). The default
is all IP addresses.
• traps—(Optional) Sends SNMP traps to the host. This is the default setting.
• informs—(Optional) Sends SNMP informs to the host.
• version {1 | 2c | 3}—(Optional) Specifies the SNMP version.
- 1—SNMPv1 traps are used.
- 2c—SNMPv2 traps or informs are used.
- 3—SNMP version 3 is used.
• noauth—(Optional) Specifies that no packet authentication will be
performed. Applicable only to the SNMP version 3 security model.
• auth—(Optional) Specifies that packet authentication without encryption
will be performed. Applicable only to the SNMP version 3 security model.
• priv—(Optional) Specifies that packet authentication with encryption will be
performed. Applicable only to the SNMP version 3 security model. Note that
creation of SNMPv3 users with both authentication and privacy must be
done in the GUI. All other users may be created in the CLI.
community-string
•
operation. For SNMP v1 and v2, any community string can be entered here.
(Range: 1 to 20 characters)
port-number
• udp-port
timeout-value
• timeout
retry-time
• retries
hostname
|
community-string
retry-time
]
ipv4address hostname
|
—The SNMP community sent with the notification
—(Optional) Specifies the UDP port number.
—(Optional) Specifies the SNMP inform timeout.
—(Optional) Specifies the number of SNMP inform retries.
ipv6address
| } [traps | informs] [version
port-number
[udp-port
ipv6address
| }
32
] [timeout
444