Address Table Commands
switchport port-security
switchport port-security
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
---------+---------+---------------+-------------+-------------------+------
-----
fa1
| Classic |
---
fa2
| Classic |
---
fa3
| Classic |
---
fa4
| Classic |
---
fa5
| Classic |
---
fa6
| Classic |
---
fa7
| Classic |
---
fa8
| Classic |
---
fa9
| Classic |
---
fa10
| Classic |
---
The following table describes the significant fields shown in the example:
Field
Port
Mode
Security
Action
CurrentAddr
Trap Freq
To enable the port security on an interface, use the switchport port-security
Interface Configuration mode command.
To disable the port security on an interface, use the no form of this command.
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Disabled
|
Description
The port number.
The learning mode: classic or dynamic.
The port security status. The possible values are
Enabled or Disabled.
The action taken on violation.
The number of addresses currently learned.
The minimum time interval between consecutive traps.
3
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
0
|
Discard|
5
97