Table of Contents
Advertisement
CDP Commands
show cdp tlv
show cdp tlv
show cdp traffic global
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To show the local device information advertised by the CDP protocol for specific
interfaces, use the show cdp tlv Privileged EXEC mode command.
Syntax
interface-id
show cdp tlv
Parameters
•
interface-id
—The interface ID or a list of interface IDs.
Command Mode
Privileged EXEC Mode
Example
switchxxxxxx# show cdp tlv fa5
CDP is globally enabled
Interface TLV: fa5
CDP is enabled on fa5
Interface fa5 is Up
Device-ID TLV: type is Host name;Value is switchxxxxxx
Address TLV: IPv4 192.168.1.254, IPv6 fe80::66d8:14ff:fe5d:6d36
Port-ID TLV: fa5
Capabilities: Switch IGMP
Version TLV: 1.1.0.9
Platform TLV: MS200X-24P
Native VLAN TLV: 1
Full/Half Duplex TLV: full-duplex
Appliance VLAN-ID TLV: Appliance-ID is 1; VLAN-ID is 1
Extended Trust TLV: extended trust
COS for Untrusted Ports TLV: 0
To show global CDP traffic statistics, use the show cdp traffic global Privileged
EXEC mode command.
Syntax
show cdp traffic global
7
118
Advertisement
Table of Contents
